Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Steps for booting ARM in an SOC

Status
Not open for further replies.
J

jeevs

Newbie level 4
Joined
Sep 13, 2005
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,338
arm boot sequence

Dear Friends,
Can any one help me out with the steps involved in Booting for ARM.I want to know if ARM is a part of the SOC design, for functional verification What is the boot sequence that is involved in the verification environment.As far as I remember the Image is copied to the FLASH memory from where the ARM starts booting up.Once the initialization is done than the verilog part monitors the interrupt set on the GPIO and kicks of the further simulation.

Please help me out in understanding more clearly..


Thanks in advance

Regards,
Jeev
 

steps of booting

In fact ,for SOC simulation, arm will boot code from flash and then configure the ddr2 controller , after the ddr2 controller is enabled, arm will read the code from the ddr or ddr2 device!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top