Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

can XC9572 interfect Power MOSFET

Status
Not open for further replies.
J

J_expoler2

Member level 4
Joined
May 10, 2003
Messages
77
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
619
Hi.
can XC9572 interfect Power MOSFET ???
how i can doing
thank.
 

In theory this would be possible however you did not mention if it is a P or N channel Mosfet?

I would think that it is best to drive your power MOSFET with a driver from linear technology (linear.com) or from international rectifier (ir.com).

The heavy capacitance present on the gate may slow down things badly.
As you did not mention which power or at which speed you wish to operate, it is rather difficult to answer correctly your question.

Cheers


J_expoler2 said:
Hi.
can XC9572 interfect Power MOSFET ???
how i can doing
thank.
Click to expand...
 

now i'm using XC9572 generate PWM for drive motor by Hibridge Power MOSFET but i'm not sure it interface directly
thanks.
Best regards,
 

In a brifge, if the Power supply exeed 12 volts, you definotely need an interface between the CPLD and the FETs.

These drivers from linear would definitely be an advantage as they are not expensive and are 'design to do the job'..

What current and voltage does your bridge should handle?

Cheers
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top