Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Weak inversion biasing - need for or advantage of

Status
Not open for further replies.
M

mickey_melomane

Member level 2
Joined
Jun 16, 2006
Messages
47
Helped
5
Reputation
10
Reaction score
2
Trophy points
1,288
Location
Columbus, OH
Activity points
1,571
weak inversion

What is the (need for/advantage of) biasing a transistor in Weak inversion region? Plz list some tutorials if anyone might know!

Sidharth
 

weak inversion current source

largest gm/ID for MOS
 

gm in weak inversion

plus you also get better bias margins
 

Re: Weak inversion biasing

Could you please explain in detail as to why you need larger gm/I ratio... and what is meant by bias margin... Shouldn't Vgs increase for higher drain currents, provided Vd does not fall below Vdsat...?
 

Re: Weak inversion biasing

Biasing in weak inversion means making the device much larger so that the VGSeff is not much to drive the required current. So VDS sat becomes low which provides more voltage range where the devices work properly.
More gm provides more gain. gm can also be improved by increasing I., which makes gm/I the figure of merit.
 

Weak inversion biasing

Does the same thing apply to the input transistors of a 5-T NMOS input differential amplifier?

Or which amplifiers of a 5-T diff pair, be biased in weak inversion. (assuming current source load or current mirror load)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top