Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

created multilayer from single layer using ADS2008

Status
Not open for further replies.
D

darthvader14

Newbie level 3
Joined
Feb 26, 2009
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,298
helo, im newbie here request some help. im creating 2.4G ltcc lowpass filter, im already done creating a single-layer layout, but donno how to transfer that design to multilayer layout :cry:

im using ads2008, any paperwork or references that i have to refer???
thanx 4 ur time ...
 

If you do the single layer design ( micro strip) then it is valid for that case.
You need to redo the design for multilayer as there is no tool that converts single layer design to multilayer design.
 

can u become more specific? coz i really2 new with this ads software . where can i get a manual @ tutorial in case of creating multilayer..
thanx...
 

Hi, seen the example that u give, very helping..:D , but can i change the value of inductor n capacitor?? how can i do that??
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top