AndyECE
Member level 5
I am using ansoft designer to look at the far-field voltage pattern of a dipole. It simulates just fine, and I can create the output reports, but It automatically defaults to
Theta: 0 to 180 degrees, 10-degree increments.
Phi: 0 to 180 degrees, 15-degree increments
I cannot figure out how to change the step size of the angles. I would like it to be smaller steps. Any help?
Theta: 0 to 180 degrees, 10-degree increments.
Phi: 0 to 180 degrees, 15-degree increments
I cannot figure out how to change the step size of the angles. I would like it to be smaller steps. Any help?