kewl
Newbie level 2
Hi to all!
I would like to know if it's possible to use a ZARLINK GP2010 or
other front-end device at an other frequency than 1575.42MHZ,
on changing some external components of filters, for operate
in a ISM BAND but with the same input waveform signal ???
In fact I'm very intersted by the very high sensitivity of the
Zarlink RF front-end device.
I use a similary communication system of GPS NAVSTAR, without using
the 3 dimentional positionning.
If it is not possible with this device, could you give me
an opinion about my demodulator BPSK on ISM BAND (typically 433 or 868MHz european band). Or some website link!
Cheers,
kewl!
I would like to know if it's possible to use a ZARLINK GP2010 or
other front-end device at an other frequency than 1575.42MHZ,
on changing some external components of filters, for operate
in a ISM BAND but with the same input waveform signal ???
In fact I'm very intersted by the very high sensitivity of the
Zarlink RF front-end device.
I use a similary communication system of GPS NAVSTAR, without using
the 3 dimentional positionning.
If it is not possible with this device, could you give me
an opinion about my demodulator BPSK on ISM BAND (typically 433 or 868MHz european band). Or some website link!
Cheers,
kewl!