Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Simple Pickit2 for dspic33

Status
Not open for further replies.
M

maxwang71

Newbie level 3
Joined
Feb 2, 2009
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,299
dspic33 pickit2

I have a project using dspic33FJ64GP802, this is 3.3v device, I just want to a simple pickit2 to debug and programming it, so I modify the original schematic of pickit2, I remove the Vdd adjust part, I use one reg1117 3.3v to power my target board, because 3.3v device no need Vpp voltage, so I also remove that part, now the circuit is quite simple, but i am not sure whether it works propertly or not

give some suggestion please.
 

simple pickit 2

I dont see a picture.
 

dspic33 board

Ok, I post the picture

 

dspic33 simple board

maxwang71 said:
Ok, I post the picture

Click to expand...
pickit2 can be configured for 3.3V why all this mod?

the original pickit2 takes care and perhaps the Vtarget is changed as 3.3V, Vpp not generated, thus Vtarget will come out at vpp pin as 3.3V as well as same 3.3 is also driving all the other output elements of PGC and PGD.
why if you have a pickit2, this mod at all?
 

simple pickit2

I did not have any pickit2

I just want to make a simple one for dspic33 only
 

target layout dspic33

maxwang71 said:
I did not have any pickit2

I just want to make a simple one for dspic33 only
Click to expand...
Perhaps you can make the full compliment even. there is a pcb layout else where in this site by Nishal at
the difference is very little, in fact. and you are likely to have a full fledged version.
Sarma
 
Last edited by a moderator:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top