Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Need Cable between S7200 PLC and Touchwin

Status
Not open for further replies.
H

HN

Member level 1
Joined
Jun 15, 2002
Messages
38
Helped
5
Reputation
10
Reaction score
5
Trophy points
1,288
Activity points
276
touchwin

Hi Friends ,
I've got a Touchwin touch screen TP-562-TB model.
Where can I get connection cable between Siemens S7-200 cpu 222 PLC and Touchwin touches screen.
Has anybody got the schematic of connection cable between S7200 PLC and Touchwin touches screen?

thanks in advance
 

touchwin hmi

I don't know what interface have the touchwin device and what protocol use. But on S7-200 the interface is RS485 with gnd on pin 5 line A(Tx/Rx+) on 8 and line B(Tx/Rx-) on 3. The protocol is Siemens propietary PPI or MPI depending on settings. If your HMI have a RS485 interface and can use these protocols you can easily connect to S7-200. If HMI not support Siemens protocols, there is a possibility to configure the serial port of S7-200 on freeport mode and try to implement by software the protocol supported by your HMI. Not an easy task.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top