Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

ICD2 clone not working for dsPIC 30F2010 - verify error

Status
Not open for further replies.

UroBoros

Advanced Member level 2
Joined
May 5, 2004
Messages
642
Helped
19
Reputation
38
Reaction score
8
Trophy points
1,298
Location
Cochin - India
Activity points
6,463
30f2010

ICD2 clone Potyo version without 3.3 volt support. Working OK for 16and 18 series. But for dsPIC30F2010 it gives verify error. I think some modification are posted somewhere. cant find it .please help.
picstudent
 

dspic 30f2010 icd2 clone

Thanks, I have solved the issue.

The Cable from ICD2 to Target board needs to be short. I reduced the length and now ok
Later I added a low pass filter like arrangement mentioned by somebody in microchip forums. ie introduce a 100R resister in series in PGD line and put a 33pf on the ICD2 side of the 100R resistor. Also a 33pf decoupling like in PGC line.
With this arrangment I can connect reasonabily lengthy ICD2 cable.

Thanks
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top