Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
if the start frequency is 10KHz then you can get the value by Vout[0]
if the start frequency is some thing different then
set it as per the frequency points
use a function what(Vout) in data display. I twill show the dependency, how many points, type etc.
for your data use the expression freq[1000] then it should show 10kHz.
if not then adjust to freq[1001 or 999] then it will definitely show as 10KHz.
Put this the number in Vout[999 or 1000 or 1001] to get the required 10KHz response.
The attached document is my ADS2008 Project . I want to set the (Phase_Margin)max at 10KHz , but I don't know how to config the Goal.(the current (Phase_Margin)max is at about 1KHz ,see datadisplay)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
