Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Assigning Mesh in HFSS "Apply mesh operation"

Status
Not open for further replies.
W

wlcsp

Full Member level 3
Joined
Aug 16, 2004
Messages
184
Helped
22
Reputation
44
Reaction score
10
Trophy points
1,298
Activity points
1,511
Mesh in HFSS

Hi all,

I am using HFSS 11.1. In HFSS, it is possible to select a particular object and assign mesh operation, for example to limit number of mesh.

Before we actually run the simulation, it is also possible to do "apply mesh operation" to see the initial mesh. However, this initial mesh generation does not depend on the mesh operation assignment set earlier. I tried to change the maximum number of mesh, however, it did not change the initial mesh.

Can anyone please confirm this?

regards,
wlcsp
 

Mesh in HFSS

Its possible, please upload ur model
 

Re: Mesh in HFSS

yogeshwarr said:
Its possible, please upload ur model
Click to expand...

It is a company restricted design, can't share it.

wlcsp
 

I've had problems where I change a setting and HFSS does not realize that it now needs to rerun the simulation. Try closing HFSS, deleting the .hfssresults folder, and running the simulation again. Now the mesh operation should be taken into account.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top