Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
But I dont want to use terminal.
I want simulate some repeated data.
Like data coming from Weighing Balance..... in a fixed structure with different values. :roll:
Try the Pattern Generator Virtual Instrument (up to 1k repeatable digital pattern) or, if your repeated signal is simple just place a standard generator and wire to that.
If it's a complicated affair, use some circuitry to generate your signal, place a probe on the output line, set probe to record, then replace circuitry and probe with tape object, load recorded data set and wire to uC. Not only will this fly but if you have used analogue circuitry to generate your signal it will be a heck of a lot faster than simulating all that...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
