Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Replace Lumped Circuit Design by microstrip in ADS

Status
Not open for further replies.
T

t25

Member level 2
Joined
Jul 12, 2008
Messages
53
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,555
I don't know to replace Lumped Circuit by Microtrip in ADS. It is dificult because I don't know fomula to caculate.
Example capacitor (C= 1.728 Pf) is replaced by MBSTUB W=40 mil anh angle 60
L=3.129 nf is replaced by Mlin W=115 mil and l =300 mil
You show me to design it. (book or software or caculated)
thanks!!!
 

you can take a look at any microwave book, specifically at filters section. I recommend Microwave Engineering by Pozar. In the filters section it should explain how capacitors and inductors are realized by microstrip lines.

Notice that small segments of open-ended or short-ended microstrip line segments (stubs) act as inductors or capacitors...
 

Thanks Zottiri Kusuta
I design with frequency in range (88-108 MHz).So, microstrip such as L,C is big ???.
 

You can take a simple RLC circuit and compare it with a microstrip circuit using tune tool available in a an circuit simulator....
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top