Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Parameter setting in CST Studio

Status
Not open for further replies.
S

simi.l

Newbie level 2
Joined
Sep 28, 2008
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,295
setting parameters in cst

Hi,
I trying to design a RFID antenna for 13,56Mhz in CST Microwave Studio.
I designed several antenas as a (https://www.cst.com/Content/Applications/Article/RFID+Reader-Coil,+13.56+MHz)
but I'm not sure if generated result(S-Parametr,Smith Chart,Polar Plot,Farfields an other) from CST Studio is correct.
I'm not sure if I goot set ports,field,boundary conditions,transient solver and other parameters.
Please, can any one check or corrections mistakes if you send *.cst file ?
Thank you for your help.

simi.l@seznam.cz
 

You can see about parameter setting in CST from example of CST program. There are many example about designing in CST program. CST --> Example
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top