+ Post New Thread
Results 1 to 5 of 5
  1. #1
    Member level 1
    Points: 1,592, Level: 9
    Achievements:
    7 years registered

    Join Date
    Oct 2007
    Posts
    40
    Helped
    0 / 0
    Points
    1,592
    Level
    9

    Question about schematic symbols for ICs in Orcad Capture

    Hi all,

    I have a doubt regrading the schematic library.
    I created some schematic symbols for IC
    but they are to be created as a single part.
    So to combine them to a single part,
    I created a new part (heterogeneous) in the library and saved it.
    Then opened those single parts and copied them to the new one
    It really worked ,but the problem is that all the pin numbers disappeared.
    Why is it so?Is there any solution for this.

    •   Alt23rd September 2008, 05:49

      advertising

        
       

  2. #2
    Advanced Member level 3
    Points: 9,130, Level: 22
    cyberrat's Avatar
    Join Date
    Jun 2001
    Location
    In the sewers of the U.K.
    Posts
    846
    Helped
    78 / 78
    Points
    9,130
    Level
    22

    Schematic Symbol

    And the next question you ask is "can you read my mind? can you tell what software I am talking about?" :D
    Please do not PM me questions that are better asked in the PCB forum :)



    •   Alt23rd September 2008, 08:44

      advertising

        
       

  3. #3
    Member level 2
    Points: 1,387, Level: 8

    Join Date
    Aug 2008
    Location
    Philippines
    Posts
    53
    Helped
    5 / 5
    Points
    1,387
    Level
    8

    Schematic Symbol

    haha! yes...:D
    pcb87 can you state what software you are using...



    •   Alt23rd September 2008, 13:03

      advertising

        
       

  4. #4
    Full Member level 5
    Points: 3,768, Level: 14

    Join Date
    Jun 2005
    Location
    searching
    Posts
    281
    Helped
    25 / 25
    Points
    3,768
    Level
    14

    Schematic Symbol

    guess everyone!!!



  5. #5
    Member level 1
    Points: 1,592, Level: 9
    Achievements:
    7 years registered

    Join Date
    Oct 2007
    Posts
    40
    Helped
    0 / 0
    Points
    1,592
    Level
    9

    Re: Schematic Symbol

    Quote Originally Posted by pcb87
    Hi all,

    I have a doubt regrading the schematic library.
    I created some schematic symbols for IC
    but they are to be created as a single part.
    So to combine them to a single part,
    I created a new part (heterogeneous) in the library and saved it.
    Then opened those single parts and copied them to the new one
    It really worked ,but the problem is that all the pin numbers disappeared.
    Why is it so?Is there any solution for this.
    Oh..sorry for that
    i'm using Orcad capture



--[[ ]]--