Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

TEK THS730A input problem

Status
Not open for further replies.

gicapa

Junior Member level 3
Joined
Apr 12, 2001
Messages
26
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
95
tek ths730a

Has anyone input schema of this oscilloscope?
My problem is this: channel 2 is ok, but channel 1 is defective. When I introduce a signal in DC coupling, its amplitude is less than normal, more frequency I supply less amplitude I get. Continuos and very low frequency (< 2 Hz) are seen in right way. Instead in AC coupling all is very smaller than normal
thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top