Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Data Transfer Through USB cable from one PC to another

Status
Not open for further replies.
F

farhantariq

Member level 3
Joined
Jun 13, 2006
Messages
58
Helped
6
Reputation
12
Reaction score
4
Trophy points
1,288
Location
Pakistan
Activity points
1,600
Is it possible to Transfer data fom on PC to another PC Via USB Cable?
 

You need a bridge device, e. g. Profilific PL-2301 or PL-2302. Ready-made bridge cables are available.
 

i think you can cut a USB cable cross it like the serial cross cable
 

No. This can work with an USB dual-role or OTG controller, never with a PC.
 

mezo said:
i think you can cut a USB cable cross it like the serial cross cable
Click to expand...

Impossible! USB is a differential line Bus, No TX RX involved like RS-232.

PC is A USB host, it can communicate to a USB slave(peripheral) only.
USB bus is a host slave arrangement.

As far as I know you may need a hardware or software arrangement to imitate a slave for both hosts so that the intermediate device or software module handles the transfer.

I am also interested in knowing more about the possible methods.
Thanks

Here is a article probably our needed solution.
**broken link removed**


Picstudent
 

you can coonect two PC with a cross USB cable, but pay attention to get its software with cable from seller. I had a cross cable but I found its software from internet after a long time search.
 

well u cannot use the usb to usb connectors i.e. A/A cables to transfer the data...
for that u need a bridged usb cable.
if attempted to use the A/A cable it can burn your usb or the power supplies....
DON NOT ATTEMT SUCH A THING..

malharmoghe/Malibu
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top