Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Convergence errror problem

Status
Not open for further replies.
E

engrvip

Full Member level 2
Joined
May 3, 2006
Messages
142
Helped
3
Reputation
6
Reaction score
0
Trophy points
1,296
Activity points
2,377
*** initial damped pseudo transient completed. ***
*** final try started ***
**error** no convergence in final try for gmindc= 1.0000E-10
no convergence in damped pseudo-transient,

**error**: no convergence in operating point


I am getting this convergence error message ...............can somebody plz tell how to solve it????

thanks
 

which simulator?
which circuit topology?
 

In my experience,
Some convergence error occurs because simulator cannot find initial state.

If you give sources with VDC,
try to source (vdd & reference., etc) with rampup.
(i.e. start all sources from 0V, then ramp up to your desired value.)
for example, If vdd=3.3V, you can use vpulse or vpwl starting from 0V to 3.3V.

Regards.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top