Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Planar Microstrip Antenna Design

Is it feasible?

  • yes

    Votes: 0 0.0%

  • no

    Votes: 0 0.0%
  • Total voters
    0
Status
Not open for further replies.
P

premag

Newbie level 6
Joined
Jun 17, 2008
Messages
14
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,362
planar antennas design

Hi
I have a problem of designing a microstrip planar antenna which can operate in range<1GHz.
I need as large bandwidth as possible.So please tell me how to operate large bandwidths around 500-600MHz at such low frequencies(that means antenna operates in 400-1000MHz).There is no other constraint other than being planar.
But even if you can help me with some other designs I will be thankful to you
 

microstrip antenna

You may use printed structures on PCB starting from about 100 MHz. Half-inch long resonator will work well for this frequency even on FR4. For your task probably parallel printed dipole structure with wide elements may be used. Wire version works well for required 2.5 times bandwith.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top