Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You should check the equipment, e. g. mixer where you want to connect the microphone. There isn't a clear standard for using TRS at microphone inputs, to my knowledge. It is for stereo audio, also for send-return cables. Some equipment may require the ring shorted to the sleeve for microphone inputs, this may decrease noise supression with others.
Thanks so much for the info.
I'd probably be taking on more than I can handle but I might give it a try.
That Sweetwater info tells a lot. I didn't know they had so much tech information.
thanks.........
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.