Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
First select the device then follow th below mentioned instructions to simulate & analyse the Power Amplifier in AWR Microwave Office (MWO)...
Step 1: Get the IV Curves by placing the model & IV Curve tracer measurement block--If these results are matching with data sheet results then
Step 2: Build the small signal ideal Biasing Circuit for the device & then get the S-parameters & see the expected gain & Return losses are matching or not then
Step 3: Build the Large Signal circuit with output & input matching network for the device & tune/optimize the network parameters to get desired output Gain, power, spectrum results then
Step 4: then build the layout & export it as Gerber/DXF file
The following two articles provides very good reference points for PA design using MWO...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
