Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to simulate the "Poly_phase Filter" ?

Status
Not open for further replies.
hi
what software you are using for your simulation of filter and at what frequency is your requirement mention all those things clearly here
 

Hi,

If u intend to use vs POLYPHASE filter in order to make SSB u must take care also
I/Q mod.

I did it in ADS vs HB.
general idea in my design was:
Single ended signal was transformed in to the balanced (balun), after that u have PolyPhase Filter and after that u put IQ mod model (i don't have it so i built it also).

David
 

there are many smulatrs can be used for this task

khouly
 

These are used at a low enough frequency that any SPICE type simulator can be used. If you want to be more accurate you can put a small inductor in series with the capacitor (in the simulation) to take care of SRF.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top