Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Genesys Active filter design transfer to ADS not working OK

Status
Not open for further replies.
E

erno

Junior Member level 2
Joined
May 11, 2007
Messages
23
Helped
5
Reputation
10
Reaction score
3
Trophy points
1,283
Activity points
1,434
ads active filter

I made an active op amp low pass filter design in Genesys and exported the design to ADS. When using the design in ADS the filter passband and stopband look like in original design but the insertion loss is more than 240 dB. Has anyone faced this before?
I tried to change the port impedances but did not get the same results as in Genesys. Filter loss in Genesys was -6 dB. Genesys port impedances were 100e-12 ohms at the input and 1e12 ohms at the output (tried the same in ADS but no help).

Help would be needed.

BR
 

Re: Genesys Active filter design transfer to ADS not working

Hi,

I tried some time to design in Genesys Active LowPassFilter,
Unfortunately eagleware can't design this one!
Trule i did not try to built it in ADS but Pspice make it perfectly!!!

David
 

Re: Genesys Active filter design transfer to ADS not working

OK. Basically the response is OK, the only thing bothering me is the insertion loss level shift so much down. Have to ask the supplier.

Regards

Erno
 

Re: Genesys Active filter design transfer to ADS not working

hello,
r oyu sure about the dimensions (mills, mm) are same when importing file to the ads from u r genesis active filter design.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top