Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Repeat structures with HFSS

Status
Not open for further replies.
S

ssayan79

Member level 1
Joined
Sep 25, 2007
Messages
34
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,505
Hi
I'm doing a simulation in hfss and i need to repeat a cilinder along a line with a rate , as if i had an array of cylinders. Is possible to do this with hfss??

thanks
 

Hello Sayyan79

I would use a subordinate coordiate's system which has a center located along the axis on which you want to split the cylinder and after this I would rotate the solid around the plane that you just translated; for example if you want to locate the cylinders along the y-axis move the xz plane along the y axis creating a coordinates' subsystem named x'y'z' and then rotate the cylinder around z' axis of 180°;repeat the procedure how many time you need.

Hi, I hope I had been clear
 

when you use duplicate, you can specify how many elements gets formed.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top