Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

how to use ip core and design core?

Status
Not open for further replies.

zhoury

Junior Member level 3
Joined
Apr 25, 2002
Messages
26
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
172
I have two question :
1.Have anybody experience in designing asic using ip core . And what kind of core do yur use.?
2.I want to summerize our previous design work .And i want to make some ip core for next usage.For example fifo and control unit.
Which tool do i need?
Any comment will be appreciated.
 

If you using X1|1nx Coregen, there is a
IP capture guide and tool to package
parameterized IP. Otherwise, looking
for design reuse guide for general guidline.
 

Hi yechen,

1)If your design includes popular components like PCI, DMA, DSP, RISC etc. you better buy them. There are many availabe cores you can choose from, and they are tested by suckers who bought these cores before you did! Using IP cores will dramatically reduce your verification effort (and design of course).
You can ask your ASIC vendor to recommend some cores.
2) You don't need any special tools. Just make sure that your documentation is clear, cores are vendor-independent and parametrizable (recommended).

regards,
Buzkiller.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top