Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

can anybody explain me the design steps for an RF mixer

Status
Not open for further replies.
1. Design start from the specifications: convertion gain, noise figure, IP3, current consumption, ...
2. Select mixer circuit type: passive (diode,...), active (Gillbert cell, ...), single balanced, double balanced, ...
3. Circuit design: CMOS, BJT, ...
DC: bias, current, ...
AC: gain, NF, IP3, ...

This is my experience, just for reference.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top