Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem with displaying output of ML401 FPGA in the hyperterminal

Status
Not open for further replies.
M

moraali

Newbie level 3
Joined
Feb 25, 2008
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,312
Good evening,

I have done the tutorial (EDK 9.2 MicroBlaze Tutorial in Virtex-4). I am using Virtex4 ML401, not ML403. However , when I opened the Hyperterminal, the Hyperterminal does not display any output.
My lecterer told me the problem might occur because when using the BSB the revision board is only '1'. But my board is is written 'B'. Is it true? How to rectify the problem? How can I have the hypertermnal output display something?

Please reply to me as soon as possible
Thanks
 

Re: FPGA ML401 problem

if you are doing edk project you will need to have the right opb_mdm device.

opb_mdm_v2_01_a
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top