Lord Banshee
Junior Member level 2
Want to design a PCB with an FPGA on it, but it seems i can not find "official" documents from Altera or Xilinx on how the pins should be connected. On most circuits i've used (simple ICs in comparison) there is always a typical circuit to go by. I've looked at some FPGA dev board schematics and it seems like the only resources i have, but i wonder if there was something from the vendors?
Any help would be great, or guide lines that i should follow, like how there is always many different size caps for noise isolation fro VCC to GND.
Thanks,
Chris
Any help would be great, or guide lines that i should follow, like how there is always many different size caps for noise isolation fro VCC to GND.
Thanks,
Chris