Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I do not think there is any specific command to simulate 1/f noise ONLY. What you can do is to do a noise analysis (AC or PSS), start with very low frequency, then you should be able to see the 1/f noise contribution at low frequency depends on your biasing of your MOSFET
If you use Cadence Spetre to do the noise analysis, choose the "frequence" as the "sweep variable". After the simulation, you can choose the “Results”->“Print"->"Noise Summary”.Then a "Noise Summary" window will appear. after filling the form, it will show all the noise in the schematic, the flick noise will have a symbol as "fn".
If you need more information about the "Noise" analysis, you can consult the documents of Cadence IC 5.141
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.