Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

steay state energy criterion has not been satisfied

Status
Not open for further replies.
S

shahid78

Full Member level 5
Joined
Jul 29, 2006
Messages
288
Helped
34
Reputation
68
Reaction score
14
Trophy points
1,298
Activity points
3,294
when i try to simulate some structure in CST MWS at the end of simulate a warning message comes which says

"maximum number of pulse widths simulated ,solve stopped
please note that steady state energy criterion has not been satisfied"

now i get results like S parameters so i am thinking whether i should trust such results when this warning message also comes up.
or results are totally wrong

also whats the reason for this warning message and how could i avoid it.

i get no warning message for one particular model but when i run the parametric analysis i get this warning message for some sweeps

anyone having any clue to solve this problem or any comments would be highly appreciated

thanks
 

Hi,

This warning message usually pops up when dealing with a resonant structure. You can trust the results up to a certain extent. For example, if you are interested in S-parameters, it is ok to determine the resonance frequency. Also, take a look at the time signal, if most of the energy has vanished and all the rest is just oscilating then you can be sure this warning is due to resonance.

How to deal with it?
There are many ways that I can think of, but if I assume that your structure is a resonating one, as a first step, I'd try to increase the "number of pulses" in the transient special settings.

Good luck,
P.
 
hi pushhead

thanks for your useful comments. i will try to do what u have recommended and get back to you if i face any problem

regards
 

when i try to simulate my structure (in addition my structure has very big background material )in CST MWS at the end of simulate a warning message comes which says
"maximum simulation time reached ,solver stopped
please note that steady state energy criterion has not been satisfied"

what should I do to avoid this warning?
the best
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top