Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Noise from motor run by PWM

Status
Not open for further replies.
S

smiles

Advanced Member level 4
Joined
Jul 27, 2007
Messages
110
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
2,096
Hi! My friend design a motor controlled by PWM, the frequency is 100Hz, but he don't like the noisy when motor is running, do you think of anyway that stop this noisy ?
And a small question, do you know any IC that allow you to load a song and play it ?
Thanks !!!
 

100 Hz PWM is a very low frequency. It is possible to obtain much better results increassing PWM frequency ( i.e. 10KHz ).
 

Hi ! But I been said that increase frequency too much also not good ? Is that right ? Why ?
Thanks !!!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top