Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
in parametric analysis window set all you want to run (obviously without models). Set your save nodes, outputs conditions etc.
Then go to TOOL -> Save and save the script. Then you can modify this little piece of code and change the model libraries. It is actually quite simple.
Then in root cadence window load your script and it will run sims. for you. You can go fancy with saving outputs to a file - great for PVT simulations.
Re: parametric analysis nested with corner analysis in caden
you mean if I have 17 corners to sweep then I should modify the code 17 times manually?actually I'm trying to find a one-time setting or code to run all parametric analysis and corners, I try to combine the parametric script and corner script in many ways, but failed.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
