Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Stepper Motor Interfacing

Status
Not open for further replies.
J

jitendrabatham

Junior Member level 2
Joined
Sep 29, 2007
Messages
22
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Pune
Activity points
1,413
Hello Friends,

Can any one tell me that how i interface Stepper moter with my 8051 microcontroller,


Regards,

jitendra Kumar,
Pune
 

u can use the port 2 for connecting the stepper motor to the microcontrol through a driver interface, use 2003, 2803, 5804 or use tp120 for driving
 

Thnx Nikhil for you kind reply,

I will do acc. to u.

ok
 

how i connect the stepper motor with 89c52 (directly or with interfacing with ic)
 

ibrahem Atmel said:
how i connect the stepper motor with 89c52 (directly or with interfacing with ic)
Click to expand...

what type of stepper are you using? you cannot connect a stepper directly to the micro since output current from ports is to small. you nee a driver. such as l297 etc
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top