Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help me design an 8-outports divider using Serenade 8.71

Status
Not open for further replies.
J

jiafeima

Newbie level 2
Joined
Sep 9, 2003
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
9
about divider

Hello!every one
I'm designing a 8-outports divider now. Freq is from 8GHz to 18GHz ,I fell very difficult because the practice is worse than simulation.
i use SERENADE8.71A
Can someone give me a practice ?
Thanks a lot!
 

about divider

You used a wrong simulation softwave. You should use one of EM simulation softwave , such as sonnet, IE3d et..
 

Re: about divider

What type of power divider are you using? If you use typical Walkinson power divider, it may not work. It seems to me that you need a relatively wideband power divider. You may want to search literature on IEEE papers for wideband power divider. Hope this help !!
 

Re: about divider

Place a drawing here incl dimensions. Thi would help us to trace down to the problem.
 

Re: about divider

After simulating by Serenade you must check results by using Ensemble software from Ansoft.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top