Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Need an FPGA board for realizing (S)ATA over Ethernet

Status
Not open for further replies.
S

staraimm

Full Member level 2
Joined
Oct 21, 2006
Messages
133
Helped
5
Reputation
10
Reaction score
1
Trophy points
1,298
Activity points
2,178
I want to realize the (S)ATA over Ethernet. Can anybody suggest me a FPGA board to realize that?

ethernet <-> FPGA <-> (S)ATA

Thanks a lot.
 

Re: Need a FPGA board.

Did anybody do the design of the (S)ATA over Ethernet? Any suggestion is appreciated.
 

Re: Need a FPGA board.

You can use MAX Plus 2 FPGA board.
 

Re: Need a FPGA board.

How about a Virtex 5 ?
 

Re: Need a FPGA board.

Commonly, the Virtex IV and V are very expensive. Do anybody know a cheap FPGA board?
 

Need a FPGA board.

i think max plus 2 is enough.. virtex is usually used in dsp... using virtex is an overkill
 

Re: Need a FPGA board.

reyge, I need a FPGA board, not only the FPGA chip. Can you give me a suggestion? Thanks a lot for your reply.
 

Need a FPGA board.

If you search in xilinx website you will get Ethernet supported boards. So, you can use those boards for your design.
 

Re: Need a FPGA board.

this is a low cost board and supports Ethernet from xilinx

**broken link removed**)and
 

    S

    staraimm

    Points: 2
    Helpful Answer Positive Rating
Re: Need a FPGA board.

Thanks a lot for everyone's reply. I think I have to search the board on the xilinx website.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top