Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

hfss and very large mesh setting

Status
Not open for further replies.
J

jcy

Junior Member level 3
Joined
Jul 21, 2006
Messages
26
Helped
3
Reputation
6
Reaction score
0
Trophy points
1,281
Activity points
1,479
extremely large mesh hfss

Has any one had a problem when using mesh settings (either manual or lowering the value of the lambda refinement of initial mesh) in computing far-fields. We have noticed that sometimes when we set these mesh properties too high, the far field calculation becomes garbage even though the S-parameters are correct. Any thoughts are appreciated.

Thanks,
JOhn
 

I have a problem with the mesh too, i have tried to change the number of passes and then the central frecuency of my simulation was changed I don`t know what to do for adjust the number of max passes
 

I'm not sure by your reply if you are having the same problem I am or not. I will say that it doesn't seem to be directly related to a problem with the number of tets in the mesh. If I do not set any initial mesh settings and let it run until the memory is maxed, the radiation pattern is good (although possibly not convered). I only notice a problem when I set a (too?) fine initial mesh. In both cases, however, the final number of tets is approximately the same.

John
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top