Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PWM and DC Busbar Voltage

Status
Not open for further replies.
Maverickmax

Maverickmax

Advanced Member level 1
Joined
Dec 6, 2004
Messages
404
Helped
8
Reputation
16
Reaction score
3
Trophy points
1,298
Activity points
3,689
Hi

I have set a microcontroller up to produce 3 phase for AC motor and I have noticed that the recurring noise patterns appears on my oscilloscope when I put my probed on the zero voltage busbar. Why is that? How to remove this problem?

MM
 

1- what kind of microcorntroller do you use?
PIC is better in this category

2- you can seperate the analog GND and the digital GND
its very important

regards
 

to amiralib:

why is it important to seperate the analog GND and the digital GND ???:cry:
 

hey ..Can anybody plz tell me...how can i control ...motor direction using the H-bridge...drive..sth,,LD319..sth like that..i m stuck???/
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top