Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Why I can't load my code to PIC16F877A

Status
Not open for further replies.
H

hbaocr

Full Member level 4
Joined
May 13, 2007
Messages
232
Helped
25
Reputation
48
Reaction score
4
Trophy points
1,298
Location
Hochiminh City university of technology (VietNam)
Activity points
2,765
winpic pic16f877a

hello, everyone
Can you help me? Why I can't load my program to PIC16F877A.
I use WinPIC 800 Programer ,and loader circuit is propic 2.
can you help me!
I think I have a mistake while changing some parameter in setting menu of Programmer winpic 800
PLZ tell me more Info about the parameters in WINPIC800
 

picpgm gtp lite

Hi!
Go to the settings tab and then hardware to set the hardware to the type that you are using.Also check if the chip is write protected.Write protection can be disabled by first erasing the device completly.
Regards.
 

Hi!
After clicking the "settings" tab you will see what i have posted . In the selection of hardware window select the your hardware, as i have selected.
Regards.
 

hbaocr said:
hello, everyone
Can you help me? Why I can't load my program to PIC16F877A.
I use WinPIC 800 Programer ,and loader circuit is propic 2.
can you help me!
I think I have a mistake while changing some parameter in setting menu of Programmer winpic 800
PLZ tell me more Info about the parameters in WINPIC800
Click to expand...

Check your LVP pin if it is connected to the ground.
 

hbaocr said:
hello, everyone
Can you help me? Why I can't load my program to PIC16F877A.
I use WinPIC 800 Programer ,and loader circuit is propic 2.
can you help me!
I think I have a mistake while changing some parameter in setting menu of Programmer winpic 800
PLZ tell me more Info about the parameters in WINPIC800
Click to expand...


use picpgm program is auto:idea::D
 

hello I also facing the same problem with the winpic800 ver. 3.55b.
my loader circuit is GTP-USB-Lite.
I am using the RS232 cable to connect the PIC burner to my pc.
but the burner just wont detect the PIC16F877A.
Pls help me.
Thanks.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top