Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Which IC should I use to amplify the ECG signal up to 1000 gain?

Status
Not open for further replies.
M

mirza215

Newbie level 2
Joined
Dec 4, 2006
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,293
WHICH IC SHOULD I USE TO AMPLIFY THE ECG SIGNAL UPTO 1000 GAIN AND ELIMINATE NOISE TO MAKE IT LOOK CLEAR.
 

ecg signal passive filters

try using an opamp to achieve this.... Generally for this purpose instrumentation amplifier is used due to its high gain along with high CMRR...
 

Re: ECG SIGNAL

i used AD624 form analog devices for my project. also i used ad712 for better noise canncellation and amplification.

you can request a few samples form analog devices.
 

ECG SIGNAL

Hi dont use single stage amplifier use multiple stage op-amp amplifiers with passive filters.That will reduce your noise and Use minimum 12 bit ADC.U can also visit texas and analog device site and find out medical application journal
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top