ikiraz
Newbie level 1
u2270 pcb
Hello everybody,
I had a problem with U2270b based circuit which is designed by myself. Everything is OK when antenna coil is away approx >=4 cm from circuit board and I can read TAGs properly in this distance. When I put the coil closer than 4 cm, data output of U2270b is confused (affected by 125KHz antenna signal) and so I can not read TAGs unless I put away the antenna coil again. I must put the antenna coil just up on the surface of circuit board. Would you give me a propasal regarding this issue pls.
Thanks ,
Hello everybody,
I had a problem with U2270b based circuit which is designed by myself. Everything is OK when antenna coil is away approx >=4 cm from circuit board and I can read TAGs properly in this distance. When I put the coil closer than 4 cm, data output of U2270b is confused (affected by 125KHz antenna signal) and so I can not read TAGs unless I put away the antenna coil again. I must put the antenna coil just up on the surface of circuit board. Would you give me a propasal regarding this issue pls.
Thanks ,