Xjack
Newbie level 3
i am using IR2110 and 740 for motor control
in my circuit i use 100ohms resistor and 1N4148 in parallel HO,LO to Mosfets Gate.
47ohms at VS pin.
inputs volts is 280v.
the mosfet gets heated more 80 deg.
but the motor runs well.
what can be the problem ?
did i need to change the resistor values if this is the problem please tell me where i am wrong.
in my circuit i use 100ohms resistor and 1N4148 in parallel HO,LO to Mosfets Gate.
47ohms at VS pin.
inputs volts is 280v.
the mosfet gets heated more 80 deg.
but the motor runs well.
what can be the problem ?
did i need to change the resistor values if this is the problem please tell me where i am wrong.