Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ORCAD Layout Errors although No DRC Errors flagged

Status
Not open for further replies.
T

Testhaus

Newbie level 1
Joined
Jun 17, 2007
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
ORCAD Layout Errors after autorouting, Although NO DRC Errors were flagged:
(Lay-Err1)
This Error was under silkscreen print and therefore not visible:
(Lay-Err1b)
This error shorted the the output of an fine pitch IC to VCC and destroyed it.

There were other errors:
(Lay-Err2,Lay-Err3)
which fortunately did not harm the circuit.


This is really worrying.

What causes these errors ?
How to avoid these errors ?
How can these errors be detected ?

Thanks, Dix
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top