Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: I'm Need shematic for ACTEL ISP cable for ProASIC/ProASI
For pro Asic plus I did buy the flash pro progtammer. It comes with no schematic. Reverse engineering is always a possibility, but there is an actel device inside.. Surprise .. surprise.. So even if you found the flashpro programmer schematic, quite useless..
Cheers
Re: I'm Need shematic for ACTEL ISP cable for ProASIC/ProASI
One can buy a parallel port ISP cable from Actel which is about $100 but supports only few devices among the ProASIC_Puls family. FlashPro is about $800 and supports all devices in the ProASIC/ProASIC_Plus family.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
