Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

does any one knows how to use I2C in TMS320c6713 DSP

Status
Not open for further replies.

Jeeva

Junior Member level 2
Joined
Nov 18, 2006
Messages
22
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,281
Location
Bangalore
Activity points
1,390
hi all,
i trying to interface EEPROM and RTC with my 6713 dsp using I2C bus which is inbuild module in 6713. I have written code based in the documents given my code is working in DIGITAL LOOPBACK mode. but when im trying ti write some thing to EEPROM or RTC i didnt get any acknowledgement from slave. i have tried by many way when ever im writing to slave the NACKMODE bit on I2CMDR should become zero. and onemore problem is when i give START , the bus will become busy (that is the BB bit in i2CSTR is one). can any one help me in this problem.

thanks and regards,
-jeeva
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top