Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i dont know how write the source code in assembly language..pls guide me.. i want to know to calculate the pulse and how to translate it to assembly language..thnx
Programming PIC Micro Controllers with PIC Basic , by Chuck Helleybuyck, chapter 6, project #6 will solve your problem.
See if you could find the book at edaboard.
I am trying to interface a dc servo motor with pic16F877A, the code is written in
Basic. I don't see the hardware responding at all to the code. I think it is because of the initialization of the configuration bits. So can you help me out with what and how to initialize parameter in Basic.
Post your code along configuration bits, hopefully some one will help you.
Its been years since I last used basic, but hopefully will be able to give some inputs.
What you have to do is post your code.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.