Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Operating voltages of enameled wires.

Status
Not open for further replies.
B

bunalmis

Full Member level 5
Joined
Jan 3, 2003
Messages
275
Helped
19
Reputation
38
Reaction score
13
Trophy points
1,298
Location
Ireland
Activity points
2,169
Can I apply 200V to twisted enameled (for coil) wire?

I need two isolated secondary coils for the smps. Effective coil volume of smps core is too small and I dont want to use paper or tape for the coil isolation.

Secondery coils induce only 20v but this seconders will work at the 200v potantial points.

What is the limits for isolation voltages for the enameled wires?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top