ayeong
Full Member level 1
orcad intersheet references
Hi,
Currently I'm using Orcad Unison Suite and have some problems in creating libraries.
1. Is there any way to to insert a bar over a particular pin name ? For example, usually chip enable (CE) pin is active low. Thus, is there a way to place a bar above CE instead of writing /CE ?
2. Is there a more efficicent way of searching a particular part number in the libraries ? Currently, I have to load each individual library and search for it. Kinda of troublesome.
Kinda of miss PowerLogic whereby the above mentioned stuff could be easily implemented.
Thanks.
Best Regards
Hi,
Currently I'm using Orcad Unison Suite and have some problems in creating libraries.
1. Is there any way to to insert a bar over a particular pin name ? For example, usually chip enable (CE) pin is active low. Thus, is there a way to place a bar above CE instead of writing /CE ?
2. Is there a more efficicent way of searching a particular part number in the libraries ? Currently, I have to load each individual library and search for it. Kinda of troublesome.
Kinda of miss PowerLogic whereby the above mentioned stuff could be easily implemented.
Thanks.
Best Regards