Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

About the "Floorplan Editor"in Max+plus2

Status
Not open for further replies.
R

RemyMartin

Junior Member level 1
Joined
May 12, 2003
Messages
17
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
133
I am just a beginer fo FPGA and I've got to know a little about Maxplus2,but I still dont konw how to use the "Floorplan Editor".My teacher told me that I should not use this tool if not necessary,but he did not give me further explanation.Can you give me some ideas about this tool?
 

I think at least you have to doing "pin assignment" when you finish your CPLD project! seeing the "Getting Start" of MPII, you can download it from ALTERA's website, it's helpful for beginner.
 

tutorial for maxplus2

You can try to read this tutorial.
 

By default, Max-plus II would assigned ports in your design to the pins on the device automatically. Sometimes, one pin of A1 could be assigned far off from A2. So, Floorplan Editor is used for pin assignment. You can assign those 2 pins next to each other manually - using Floorplan Editor.

Note: Altera has a newer version of Maxplus II - called Quartus. It should have better features.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top