Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Here are some application notes from Motorola on RF power design.
**broken link removed**
Transistor power amplifiers are usually broad band type because of the danger of damaging them if driven into a reactive load such as outisde the tuning range of a narrow band network. You can follow one of these amplifirs by a band pass filter if you need it.
The output power is 1 Watt for 50 mili volt at input..
must first habe pre amplifier with 200 gains(23 db)_ at narrow band.
if you design with 2n2219 & 2n2905 its good for him!!!!!!!
is this information alot ???
thanks in advance
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
