Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

RF PCB Track calculation

Status
Not open for further replies.

palam_rect

Newbie level 3
Joined
Oct 18, 2006
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,306
I am trying to make a rf switch board with one input and two outputs.
Using that input signal can be connected to any one of output depending
upon the control signal.

My Requirement is track's impedance should to be controlled to 50 ohm.
How to do these ?

Since , it is very simple switch circuit, with single switch IC,
I am planning to do it with free softwares. Is it possible to do ?

Is there any sample designs/eval board designs available in internet ?


regards,
palani
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top